In this part, we’ll implement the concept from last week’s post. We will print the brackets and mount the DIN rail. If you missed the concept, read more in the last block post. If you want to learn how to … Read the rest

This post is only about the upcoming electronics mount design. I changed a lot, I found it very difficult to came up with a design. The first design was some kind of compact housing like the original design with the … Read the rest

The gripper is an easy to assemble part. I had some issues with the servo horn. I could not find the correct one, so I designed and printed it myself. Because I changed the serv horn I had to change … Read the rest

The 4rd module comes with some issues, that we had to solve. The motor I chose did not fit inside the 4M1 part, and the bad print quality from my 4M1 part forced me to file some layers down. If … Read the rest

This week’s blog post is the second part of the part 9 assembly. We’ll start with the step 4 and finish the Module 3 in this post. If you don’t have read last week’s post, check it out here.

DIY

The 3rd module does not come with bigger issues. It was quite convenient to set everything up. In the last part, I made a mistake where I glued the M3 brass inserts into the hole. Now I knew that there … Read the rest

In this part, we will build the “Module 2” of the BCN3D Moveo robot arm. The manual did not show us how we can install the belt at the end. In this post, there is a chapter specifically on this … Read the rest

At first, I would not have included this into the weekly updates because I thought it should be trivial to screw the parts onto the plate. But I had some difficulties doing it, and I think this are the more … Read the rest